More On Minerva Cervical Thoracic Orthosis

Application Instructions:

• Log roll patient to one side assuring that the head and neck position is maintained.
• Place posterior thoracic and occipital component into position. Loosen adjustment knobs then position components to the desired location and retighten
• Uprights may be shaped by bending over bed rail if necessary. Posterior thoracic component: Fit to clear inferior angle of the scapula. Occipital component: Should be placed for maximum total contact by shaping the aluminum spine element.
• Log roll the patient back to supine. Place anterior thoracic/chin piece component in place. Loosen knobs and position components to the desired location and retighten. Engage cervical straps and adjust as necessary and tighten knobs. Apply strap stops.
• Adjust thoracic belt circumference, remove alligator hook and loop fastener clip and trim excess. This may be facilitated with a quick-release buckle in place. Attach forehead strap with inferior edge placed approximately 1 cm superior to eyebrows.
• Adjust upright as necessary and tighten knobs.
• Superior edge flairs should be fit at sub-costal margin.
  NOTE: After all adjustments have been made, it is recommended that the brace is removed and Loctite 414 applied using all precautions necessary.

Cleaning and Care:

• Remove the rigid components.
• The rigid components can be wiped clean with a damp cloth.
• Softgoods can be hand washed in warm water (90°F – 110°F or 32°C – 43°C) with mild detergent.
• Triple rinse, squeeze, and air dry.
• Avoid twisting the material to remove water.